Peanut peeling machine
Wet method Peanut peeling machine
The wet peanut peeling machine can be used with the fried peanut production line, or it can be used separately, for the early peeling of fried peanut and canned products. The special slag removing device automatically separates small particles from the peanuts after peeling, discharging them out of machine. Such a design can avoid the phenomenon of excessive impurities in the frying process and exert pollution to the fried oil. The peeling rate of this machine is high without any broken peanuts.
Dry method Peanut peeling machine
Dry peanut peeling machine is mainly used to remove the outermost shell of peanut, also known as peanut sheller, which is a special equipment for peanut shelling. It is suitable for the early peeling of peanut butter, peanut milk, pastry foods, milk peanuts and other products. It has the characteristics of high automation, high peeling rate, low noise and no pollution. This machine is equipped with a dust suction device and a vibrating screen. The dust suction device can suck out the peanut red coat, and the vibration screen can effectively remove the peanut germ.
The working principle of peanut peeling machine
The peanut peeling machine is composed of a frame, a fan, a rotor, a single-phase motor, a screen (there are two sizes), a feeding hopper, a vibrating screen, a V-belt wheel and a transmission V-belt.
After the machine runs normally, the peanuts are put into the hopper in a quantitative, uniform and continuous manner. The peanut shells are broken under the repeated impacts of the rotor, friction and collision. Peanut kernels and broken peanut shells pass through a sieve with a certain aperture. At this time, the light-weight peanut shells are blown out of the machine body, and the peanut kernels are screened by a shaker screen.
Maintenance of peanut peeler
1. Peanut peeling machine adopts triangle belt transmission. After the new belt is used for a period of time, the tensile force will gradually stretch and loosen. So it is necessary to regularly check the tension of each transmission belt and the clearance of each mating part to adjust it in time.
2. Always pay attention to whether the speed, sound and temperature of the machine are normal. you should stop the machine to check whether the bearings are overheating and whether the fastening screws in each part are loose if you use it for a long time. If you find that they are loose, you should tighten them at any time.
3. After using the peanut peeler, remove the belt and place the machine in a dry warehouse.