Garlic peeler machine is a quiet mature peeling machine. It can also be used for cashew nuts, hazelnuts, and peanuts peeling. In some food processing industries, garlic is an indispensable seasoning. Therefore, the market for garlic is very wide. Garlic-related machines include garlic root cutting machine, garlic splitter machine, garlic mud making machine, garlic packaging machine, etc.
The garlic peeler machine consists of two parts: a peeling bucket and a discharge part. Garlic peeling machine mainly uses the powerful airflow generated by the air compressor to blow off the garlic skin. The whole process does not need to add water so that it is no pollution to the environment. Use compressed air as a power that will not damage the garlic after peeling.
1. Garlic peeling machine is a multifunctional machine, a multi-purpose machine that suitable for various material.
2. This machine has a large output that saves a lot of labor costs.
3. It uses compressed air as the power and does not cause damage to garlic. The peeled garlic is complete and fresh.
4. Dry peeling method does not require water. It will not cause environmental pollution.
5. The peeling rate is more than 98% with mature technology.
Installation and debugging:
After removing the packing of the device, it should be installed on the indoor flat ground. Connect the grounding wire first, then connect the marked power supply that matches the voltage and power of the unit according to the product manual. Connect the air compressor of the corresponding specification according to the unit.
1. If the peeling effect is found to decrease during work, the garlic residue on the inner wall of the peeling bucket should be cleaned and cleaned to maintain a high peeling rate.(Note: Turn off the power and air supply when cleaning). At the same time, clean the inlet baffle and the dirt on the cylinder shaft and discharge baffle with a clean, damp cloth.
2. The air compressor needs to drainage often by opening the drain switch to keep the compressed air of the air compressor dry, so as not to damage the parts of the garlic peeler machine indirectly.
Peeling rate is not good
Jet line deflated
Quick joint deflation
Peeled garlic damage
The number of peeling on the program control board is too large
The number of peeling on the program control board is too small
Garlic is a kind of material that is not easy to release
Garlic varieties mixed
Garlic is not enough drying
Discharge valve is not flexible
Pressure regulating valve regulates pressure too small
Lower cover cylinder failure
Lower cover solenoid valve failure
Lower cover bushing is too tight
The connector is loose
Program control board failure
With air power
With air pressure